...
NOTE: The Image Correction screen has been updated as of 25th . We are in discussion with Lab Working Group on utilizing the new windowuser interface. The main difference is that we can use colors other than the White, grey and Black to make any corrections. For now, continue to select the white, greys and black for image correction calibrations.
The main Image Correction window displays three main areas:
...
4. Click Lights Off. At this point wait for lights to cool, turn lights back on and check the White square RGB values (243242, 242, 236) again and adjust the exposure intervals if needed.
...
Figure 33. Drive enable control highlighted.
c) Image Corrections
Note: this section follows the same steps as listed in the Calibration Check section above. This needs to be completed after a Calibration. An enhance method (utilizing more colors in the write color cehecker) is being implemented , and the following steps are being updated (in progress).
Take New Picture
1. Place the 3D calibration standard on track as shown (Figure 34). The color squares must be oriented as pictured below, butted against the red reflection bar.
...