Versions Compared

Old Version 23

changes.mady.by.user Unknown User (25db168b7fe4c241018015edc8bc0000)

Saved on

compared with

New Version Current

changes.mady.by.user Unknown User (cervera)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Take a scoop of quartz sand and put it in your vessel(s) and run it as you would a sample for several minutes (~3 min should be adequate).

  2. Remove the vessel and empty out the sand. Scrub the pieces with tap water and a scouring pad and rinse with DI water. Dry with a Kimwipe, and then spray with isopropyl alcohol and wipe down with Kimwipes. If your vessel is particularly dirty run a combination of quartz sand, a little hot water and detergent (Borax). This can be run for several minutes. A thick paste will form and then you clean it as normal.

Archive

XRD Sample Preparation Hard Rock - September 27, 2022