...
STEP 3 – Correct Depth
Before you begin, look at Figure 6 to learn where the sonar dome is in relation to the ship and the drill floor. As you cross the site or settle onto the site, read the depth in meters from the Bathy2010 depth read out, rounding up or down to the nearest meter. Enter this number in Row A, the "Uncorrected Depth to Transducer" in the Depth Correction worksheet. Enter the last digit of your uncorrected depth in Row B, "Uncorrected Depth Last Digit."
Now comes the tricky part. You will need to determine your lesser and greater depth limits from the TABLE OF TRUE DEPTH FOR GIVEN OBSERVED DEPTH for your area, see example in Figure 3.
Take your depth and round down to the nearest 100 of meters, for instance, 1246m would be 1200m, 738m would be 700m. Go down the left hand column of Observed Depth until you find your number and corresponding row. Now look at your 10s of meters, for 1246m that would be 46m. Since 46 is between 40 and 50, your lesser depth limit will be in column 40 and the greater depth limit in column 50.
Use the following formula to determine the corrected depth to the transducer. This formula is used in the Depth Correction worksheet so all you have to do is plug in the numbers. Verify the worksheet is set up correctly.
F = B/10 * (D – C) + C
F is the corrected depth to transducer
B is the last digit of your original depth
C is the lesser depth limit
D is the greater depth limit
h9.Example
Let's say you read your depth at 5354 m. As shown in Figure 3, go to the row 5300. Your uncorrected depth is between 5350 and 5360, so you find your lesser depth limit in column 50 and your greater depth limit in column 60. Use the following formula to calculate the corrected depth:
F = 4/10 * (5393-5382) + 5382 = 5386.4
In this example, the uncorrected depth is 5354m and the corrected depth 5386.4 m. This example is filled out in the Depth Correction worksheet in Figure 4.
h9.STEP 4 – Complete Worksheet
Complete the Depth Correction worksheet by adding the 18.4 meters to the corrected depth. This will be the Total Drilling Depth, row H in the worksheet, which is given in meters below rig floor (mbrf) which is typically the depth given in the Operations Plan. It is important when expressing depths and communicating them to be clear on what they are relative to. If the Operations Manager or one of the Driller/Core Techs ask for a "depth" or "PDR," they typically want the depth from the rig floor but always be clear by stating that.
If desired, get the ship's draft from the Daily Operations report and enter in row "I" to get the water depth.
Figure 3. Table of True Depth for Given Observed DepthTABLE OF TRUE DEPTH FOR GIVEN OBSERVED DEPTH
Figure 4. Depth Correction worksheet
...