Page History

...

Photo 2: TS tray set to engrave small thin sections.
1 2 3 4
Image Removed
Image Added
Photo 3: Opposite side of the acrylic tray with four bins for large thin sections

...

1. Sequentially place the thin sections in the bins as numbered, with the frosted side facing up and top of thin section pointing into the chamber (i.e., oriented as the bin numbers; opposite to how wholeround sections are placed for engraving).
2. If LaserKatjie3 is open, close this application and open MarkingBuilder2. For engraving small thin sections, open the label template: File > Open > MyDocuments > TS Engraver > TS_engraver-small. MBL (or … TS_engraver-big.MBL)

Image AddedImage Removed
Figure 1: MarkingBuilder2 window of the template for labels of small thin sections

...

In the upper right part of the window, toggle to the block number that you want to edit (likely starting from 001). The corresponding block will be highlighted in the main window. In the "Character" box, edit the text pertaining to the thin section in the bin.
DO NOT MOVE ANY OF THE BLOCKS!!! (Note: Store a backup copy of the template file. Alternatively, a csv file version can also be loaded.)
< bottom top >Edit label13
15
17
19
21
23
14
16
18
20
22
24
1
3
5
7
9
11
2
4
6
8
10
12
front_Bin 7_
Bin 8
Bin 9
B Anchor_GoBack_GoBackin 10
Bin 11
Bin 12
Bin 1
Bin 2
Bin 3
Bin 4
Bin 5
Bin 6

Block numbersToggle block number
Figure 2: Layout of the template and panels for editing labels

...

Photo 4: To remove the TS tray, first lift it clear off the wholeround platform.

Photo 5: Tilt the tray sideways and pull it out through the diagonal of the chamber.