...
- With the side of the tray that you need to use facing up, and the wooden bracket extensions towards you, tilt the tray and place it diagonally inside the laser engraving chamber (Photo 1). Gently rotate and set it down until the acrylic tray completely sits on top of the whole round platform, and the wooden brackets are between the platform and the wall on both sides. Pull from the back to slide the tray towards you so that the wooden bracket is flush against the front (portside) aluminum posts of the chamber (Photo 2).
Photo 1: How to place the TS tray into the laser engraving chamber.
Photo 2: TS tray set to engrave small thin sections. 
Photo 3: Opposite side of the acrylic tray with four bins for large thin sections
...
- Sequentially place the thin sections in the bins as numbered, with the frosted side facing up and top of thin section pointing into the chamber (i.e., oriented as the bin numbers; opposite to how wholeround sections are placed for engraving).
- If LaserKatjie3 is open, close this application and open MarkingBuilder2. For engraving small thin sections, open the label template: File > Open > MyDocuments > TS Engraver > TS_engraver-small. MBL (or … TS_engraver-big.MBL)
Figure 1: MarkingBuilder2 window of the template for labels of small thin sections
...
In the upper right part of the window, toggle to the block number that you want to edit (likely starting from 001). The corresponding block will be highlighted in the main window. In the "Character" box, edit the text pertaining to the thin section in the bin.
DO NOT MOVE ANY OF THE BLOCKS!!! (Note: Store a backup copy of the template file. Alternatively, a csv file version can also be loaded.)
Figure 2: Layout of the template and panels for editing labels
- If any of the bins are empty, select and delete the corresponding labels in the temple, otherwise a label will be engraved on the acrylic tray! DO NOT OVERWRITE ORIGINAL template file.
- Label and alignment verification. To verify that the label correspond to the actual slide, tape in place a letter-size bond paper on top of the tray with thin sections.
- In the bottom toolbar, click on the "Test Marking" button. Follow the prompts.
- In the window that opens, under the Test Marking Mode, select the "Marking Laser". When ready, click the "Trigger" button.
Figure 3: Test Marking window
- Remove the engraved bond paper and review the text. Modify as needed and repeat steps 6 and 8 using a new bond paper. Once everything is correct, make the actual engraving on the thin section slides: select "Marking Laser" and click "Trigger".
- When done, collect the thin section slides from the tray.
- In removing the tray, it is important that you first lift the tray clear of the whole round platform (Photo 4)before tilting it sideways (Photo 5), else, you can break the tray and the walls of the engraving chamber.
Photo 4: To remove the TS tray, first lift it clear off the wholeround platform.
Photo 5: Tilt the tray sideways and pull it out through the diagonal of the chamber.
...
Original version created by Susan Boehm