Versions Compared

Old Version 7

changes.mady.by.user Unknown User (25dbb4e563432e130164eb69f0ce000e)

Saved on

compared with

New Version 8

changes.mady.by.user Unknown User (25dbb4e5666e819a01668361ac2d0000)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

FROSTING SLIDES: USER GUIDE


 

 

Author:

E. Fisher

Reviewer(s):

 

Editor(s):

S. Boehm, S. Frank

Management Approval (Name, Title, Date):

B. Mills (Lab Officer)

Audience:

Technicians

Origination date:

4/28/2013

Current version:

7/30/2018

Revised:

 

Domain:

Thin Section Lab

System:

Logitech LP50

Keywords:

Frosting Slides

INTRODUCTION


This user guide will help thin section technicians prepare slide for bonding to billets. For more information refer to the Logitech Thin Rock Section Production manual, available both on a Logitech thumb drive in the Thin Section Lab cabinet and Thin Section Lab computer under the "Manual" folder on the desktop. Or, refer to Operation and Maintenance of the LP50 Lapping and Polishing Machine manual, located in the black binder in the Thin Section Lab cabinet labeled "LP50, PM5 and Associated Equipment".

...


SETTING THE JIG

  1. Use the jig labeled "Frost".
  2. Clean jig and Logitech scale by wiping them with a kimwipe and isopropyl alcohol.
    1. Refer to the Logitech LP Set Up user guide for more information on scale use.
  3. Set the scale on the jig gently (Fig. 1) and wiggle the scale.
  4. The jig should be set to 1217 (just before the 17 is better).
    1. Use the middle gauge on the scale.
      1. The small dial (Fig. 1) on the bottom left side should read 12.
      2. The large face (Fig. 1) should read 17.
        1. If the jig is not set, put the Tommy bar into the holes on the main post in the middle of the jig to adjust it (Fig. 1).
          1. Rotating the Tommy bar clockwise will lower the chuck face causing the numbers on the scale to increase.
          2. Rotating the Tommy bar counterclockwise will raise the chuck face, causing the numbers on the scale to decrease.




Figure 1


LAPPING UNFROSTED SLIDES

  1. Clean six unfrosted slides by washing them with hot water and wiping them off with a kimwipe and isopropyl alcohol. Then blow dry with the air gun.
    1. If slides are stuck together, let them soak in hot water. They should separate easily after a day.
  2. Set the clean slides on the jig's chuck face over the vacuum grooves. There should be no spaces between any of the sides (Fig. 2).
    1. If there are spaces the vacuum will not seal properly.

...

22. Clean the jig by scrubbing it down with warm water and a soft brush. Then blow through the jig and on the chuck face with the air gun.




MEASURING FROSTED SLIDES

  1. Hold the micrometer with your pinkie and ring finger through the "C" part of the micrometer. Your index finger and thumb will move the dial (Fig. 7).

...