...
19. Place jig chuck face up in the sink (Fig. 6).
Figure 6
20. Scrub the jig and slides gently with a soft brush to break the vacuum seal.
...
- Hold the micrometer with your pinkie and ring finger through the "C" part of the micrometer. Your index finger and thumb will move the dial (Fig. 7).
Figure 7
2. Clean the micrometer before use by placing a piece of paper in between the two bars and closing it gently (do not apply force). Pull the paper out and repeat.
...
3. Place the slide in between the two bars and close them gently onto the slide (Fig. 8).
Figure 8
(This slide is "16")
- Take a measurement at the middle and sides to make sure that the frosted slide is even all the way across.
- Uneven slides will cause your sample to be uneven. If this happens put the slide back onto the jig and lap it down longer until it is even.
4. Organize the frosted slides into groups based on slide thickness (Fig. 9).
Figure 9
Credit
Original document was created by Emily Fisher
...